Pilz PNOZ m1p base unit Bedienungsanleitung PDF herunterladen (Seite 21)

Commissioning

Operating Manual PNOZ m1p (ETH)

20878-EN-12

Commissioning the PNOZmulti control system for the first time

Procedure:

} Wire the inputs and outputs on the base unit and expansion modules in accordance

with the circuit diagram.

} Cascading output as auxiliary output: Connect the load to CO+ and A2, see connection

example.

} Connect the supply voltage:

– Supply voltage for the units (connector X7):

– Terminal A1: + 24 VDC

– Terminal A2: 0 V

– Supply voltage for the semiconductor outputs (connector X2):

– 24 V terminal: + 24 VDC

– 0V terminal: 0 V

Please note: Supply voltage must always be applied to X2 and X7, even if you are not us-

ing the semiconductor outputs.

Load project from chip card

CAUTION!

Chip contacting is only guaranteed if the contact surface is clean and un-

damaged. The chip's contact surface should therefore be protected from

contamination, contact and mechanical impact such as scratches.

Procedure:

} Insert the chip card containing the current project into the card slot on the base unit.

} Switch on the supply voltage.

Load project via integrated interface

Procedure:

} Insert a chip card into the chip card slot on the base unit.

} Connect the computer containing the PNOZmulti Configurator to the base unit via the

interface.

} Switch on the supply voltage.

} Download the project (see PNOZmulti Configurator's online help).

Information

You will need a PC with an Ethernet card in order to establish an Ethernet

connection.

6.3.2

6.3.2.1

6.3.2.2

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Keine Kommentare

Pilz PNOZ m1p base unit Bedienungsanleitung Seite 21